Our engines are tested and guaranteed under normal driving conditions not to knock, smoke or have excessive oil consumption. This limited warranty is void if engines have been dissembled before our inspection or if the center of the installed heat tab has been melted or removed.
Accessories which are left on engines such as alternators, starters, carburetors, throttle bodies, injectors, fuel pumps, exhaust manifolds, flywheels and water pumps may be used for your convenience and are not covered under warranty.
Prior to the installation of your recycled used auto part, we suggest you perform the following pre-installation maintenance. By performing the pre-installation maintenance you prolong the life of your recycled part and warranty.
For complete warranty information please contact our sales staff or refer to your sales receipt.
- Check all mounting points, sensors and compare with recycled replacement part.
- Inspect or replace frost plugs before install.
- Replace thermostat and gasket.
- Inspect and replace, if needed, timing gears, chains or belts and gasket.
- Replace oil pan gasket and rear main seal.
- Install new spark plugs.
- Replace oil filter.
- Install new belts and hoses.
- Drain and replace engine oils with manufactures suggested grade and levels.
- Flush cooling system and refill with anti-freeze to appropriate level.
- Test electric engine cooling fan and temperatures sensor if functional.
Prior to the installation of your recycled used auto part, we suggest you perform the following pre-installation maintenance. By performing the pre-installation maintenance you prolong the life of your recycled part and warranty.
For complete warranty information please contact our sales staff or refer to your sales receipt
- Compare before installation, it maybe necessary to change wiring, linkages, kick down cable and speedometer gears.
- Install new transmission filter kit.
- Replace front and rear transmission seals.
- Replace axle seals.
- Properly align torque converter.
- Flush and inspect transmission cooling lines.
- Add fluid grade and level to manufactures specification.
- Adjust throttle position cable and sensor.
- Reset transmission computer to manufactures specification.
- Compare before installation, it maybe necessary to change wiring, linkages, kick down cable and speedometer gears.
- Replace axle or drive shaft seals.
- Replace throw out bearing.
- Replace oil grade and level to manufacture specification.
- Inspect and adjust or replace shifter cable or linkage.
- Replace pilot bushing.
- Replace clutch.
- Inspect and replace, if needed transmission and engine mounts.
Prior to the installation of your recycled used auto part, we suggest you perform the following pre-installation maintenance. By performing the pre-installation maintenance you prolong the life of your recycled part and warranty.
For complete warranty information please contact our sales staff or refer to your sales receipt
- Never work on an A/C system without proper eye protection.
- Flush and clean the system.
- Vacuum system to remove moisture.
- Always change the drier or accumulator and orifice tube.
- Rotate the compressor 10-12 times.
(before charging the system rotate the compressor 10-12 times to oil the seals. The easiest way to do this is by removing the ignition wire and crank the engine 10-12 times to rotate the compressor). - Never Liquid charge the system.
(Freon entering the system as a liquid is a major cause of broken reed valves, broken pistons and noisy compressor) - Always use gauges to check the system pressure.
(The pressure of R134a refidgerant will be significantly higher then R12)
 |
 |
|
 |
||